1895 rear spine

I think Brian will be a good person to talk to. I have tonnes of them and just to find the right one with the right length and bend, it's tough. Chance of getting a almost correct one is like one of of 15 rear spines.
 
To measure length, use a cloth measuring tape that will follow the contour of the helmet shell. Or use a piece of masking tape, mark locations, remove and lay out flat to measure. Measure from the edge of the spike base to the end of rear visor. Along this length, also measure where the split brad is located.

Ron
 
Thanks for the information Ron and Amy Just measured 8 and a quarter inches or 210 MM total length including
including slit and brad ends
 
You must log in or register to reply here.
Back
Top